Sharp AR-FX11 Specifikace stáhnout pdf (Strana 11)

BEFORE USING THE FAX

FUNCTION

This chapter contains basic information about using the fax function of the machine. Please read this chapter before

using the fax function.

POINTS TO CHECK AND PROGRAM

AFTER INSTALLATION

After installing the machine and before using it as a fax machine, check the following points and program the

required information.

Set the date and time

The machine has an internal clock. It is important to set the correct date and time because they are used for such

features as Timer Transmission (page 36).

The date and time are set in the key operator programs. (Page 101)

The date and time appear in the display. Make sure the correct date and time appear. If the date and time are wrong,

please correct them.

Program the sender's name and sender's number

The name and fax number of the user of the machine is programmed in "OWN PASSCODE SET" (page 99) in the

key operator programs. (Only one name and number can be programmed.)

The programmed name and number are printed at the top of each transmitted fax page. The sender's number is also

used as an identification number when you use the Polling function to request transmission from another fax

machine (see "USING THE POLLING FUNCTION" on page 39).

Paper sizes that can be used for fax mode

The machine can use 11" x 17", 8-1/2" x 14", 8-1/2" x 11", 8-1/2" x 11"R, 5-1/2" x 8-1/2", A3, B4, A4, A4R, B5, B5R,

and A5* size paper; however, A3, B4, B5, B5R, and A5 size paper cannot be used in fax mode. (Among AB sizes,

only A4 and A4R can be used.) For this reason, if only paper sizes that can be used in other modes but not in fax

mode are loaded in the machine, received faxes cannot be printed. (For other points regarding fax reception, see

"RECEIVING FAXES" page 30.)

* 8-1/2" x 5-1/2" (A5) size paper can only be loaded in tray 1, regardless of the mode. A5 paper cannot be loaded in tray 2 or in

the optional 250-sheet paper feed unit or 2 x 250-sheet paper feed unit.

You can check your programmed name and number by printing out the "Key Operator List" in the key operator

programs. (See "LIST PRINT" on page 97.)

For the procedures for loading paper in the trays, see the "Operation manual (for general information and

copier)".

Note

Pegasus-E_Fax_Sec.book 9 ページ２００４年９月２４日　金曜日　午後２時５１分

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 119 120

Žádné komentáře

Sharp AR-FX11 Specifikace Strana 11