Sharp SYSTEM 8/10 Plus Manuál s instrukcemi stáhnout pdf (Strana 364)

100

101

C-Link Protocol Commands

Communications Configuration

B-56 Model 5030i SHARP Instruction Manual Thermo Fisher Scientific

set allow mode cmd value

This command is used to configure the instrument to value, where value is

either 1 = accept or 0 = ignore the “set mode local” and “set mode remote”

commands, according to Table B–7.

If the instrument is set to accept the commands (value = 1), the “set mode

local” command will unlock the instrument and the keypad can be used to

make changes via the front panel.

If the instrument is set to ignore the commands (value = 0), the instrument

will respond with “ok” as if the command has been accepted and acted

upon, but will not change the instrument lock status (this is for

compatibility with systems expecting and “ok” response).

Note The instrument will always respond to the command “mode” with

the status of the password lock as “mode local” or “mode remote”,

regardless of the above setting. ▲

The following example sets the instrument to accept the “set mode local”

and “set mode remote” commands.

Send: set allow mode cmd 1

Receive: set allow mode cmd 1 ok

Table B–7. Allow Mode Command Values

Value

Allow Mode Command

0 Ignore (default)

1 Accept

baud

This command reports the current baud rate for the serial port

(RS232/RS485). The following example reports that the current baud rate

is 9600 baud.

Send: baud

Receive: baud 9600

set baud rate

rate = | 1200 | 2400 | 4800 | 9600 | 19200 | 38400 | 57600 | 115200 |

1 2 ... 359 360 361 362 363 364 365 366 367 368 369 ... 402 403

Komentáře k této Příručce

Žádné komentáře

Sharp SYSTEM 8/10 Plus Manuál s instrukcemi Strana 364

Komentáře k této Příručce

Související produkty a manuály pro Síťové přepínače Sharp SYSTEM 8/10 Plus