Sharp AH-X10BE Uživatelský manuál stáhnout pdf

LIFETIME OUTDOOR SHED EQUIPMENT

10-YEAR LIMITED FACTORY WARRANTY

THE MANUFACTURER RESERVES THE RIGHT TO MAKE SUBSTITUTIONS TO WARRANTY

CLAIMS IF PARTS ARE UNAVAILABLE OR OBSOLETE.

1. Lifetime outdoor sheds are warranted to the original purchaser to be free from defects in material or

workmanship for a period of ten years from the date of original retail purchase. The word “defects” is deﬁ ned

as imperfections that impair the use of the product. Defects resulting from misuse, abuse or negligence will

void this warranty. This warranty does not cover defects due to improper installation, alteration or accident.

This warranty does not cover damage caused by vandalism, rusting, “acts of nature” or any other event

beyond the control of the manufacturer.

2. This warranty is nontransferable and is expressly limited to the repair or replacement of defective product. If

the product is defective within the terms of this warranty, Lifetime Products, Inc. will repair or replace defective

parts at no cost to the purchaser. Shipping charges to and from the factory are not covered and are the

responsibility of the purchaser. Labor charges and related expenses for removal, installation or replacement

of the shed or its components are not covered under this warranty.

3. This warranty does not cover scratching or scufﬁ ng of the product that may result from normal usage. In

addition, defects resulting from intentional damage, negligence, unreasonable use or hanging from the truss

will void this warranty.

4. Liability for incidental or consequential damages is excluded to the extent permitted by law. While every

attempt is made to embody the highest degree of safety in all equipment, freedom from injury cannot be

guaranteed. The user assumes all risk of injury resulting from the use of this product. All merchandise is sold

on this condition, and no representative of the company may waive or change this policy.

5. This product is not intended for institutional or commercial use; Lifetime Products, Inc. does not assume

any liability for such use. Institutional or commercial use will void the warranty.

6. This warranty is expressly in lieu of all other warranties, expressed or implied, including warranties of

merchantability or ﬁ tness for use. Neither Lifetime Products, Inc., nor any representative assumes any other

liability in connection with this product.

ALL WARRANTY CLAIMS MUST BE ACCOMPANIED BY A SALES RECEIPT.

To register the product, visit our Web site at www.lifetime.com

REPORT PRODUCT DEFECTS IN WRITING TO:

Lifetime Products, Inc., PO Box 160010 Clearﬁ eld, UT 84016-0010

or call (800) 225-3865 M-F 7 a.m. to 5 p.m. MST.

Please include your dated sales receipt and photographs of damaged parts.

www.lifetime.com

PO Box 160010 • Freeport Center, Bldg. D-11 Clearﬁ eld, Utah 84016-0010

T: 800-225-3865 • F: 801-728-1907

gXg/UTDOOR3HED

/7.%23-!.5!,

WITH!SSEMBLY)NSTRUCTIONS

1 2 3 4 5 6 ... 19 20

Shrnutí obsahu

Strany 1 - /7.%23-!.5!,

40LIFETIME OUTDOOR SHED EQUIPMENT10-YEAR LIMITED FACTORY WARRANTYTHE MANUFACTURER RESERVES THE RIGHT TO MAKE SUBSTITUTIONS TO WARRANTY CLAIMS IF PARTS

Strany 2 - 1 (800) 424-3865

10Place Screw (TC) in this hole to keep window from sliding up too far. Insert until ﬂ ush with the window.3.1: Remove plastic sheeting from Window (A

Strany 3 - Read This First!

3014.7: Install next Truss.14.8: Follow steps 13.2-13.4 to place the next Roof Panels (114) and Roof Supports (AI). Repeat for other side.14.9: Positi

Strany 4 - IMPORTANT! Please Read

126.1: Insert two Wall Panels (108) along back side of shed. Fasten panels with Screws (SS). Make sure holes line up.6Back Wall AssemblyDo Not Over-Ti

Strany 5 - Anchor the Shed

28The Roof Support ﬁ ts into the notches in the Roof Panel (as shown).14.3: Secure the Roof Panel to the Front Gable and Truss Channel with all but th

Strany 6 - 118 1/4”

148Left Door Assembly8.1: Rest Left Door (118) on the ground with front side down. Position Deadbolt Latches (HM) in slots at the top and bottom of do

Strany 7

2613.3: Slide a Threaded Rod (SA) through the Truss Support Brace and the top of the Truss Connector.HL (6)3/8” Wrench13.4: Secure the top and bottom

Strany 8 - OPTION 2: Filled Wood Frame

16HR (2)Hardware Bags:1033168, 10334187/16” Wrenches (2) ScrewdriverHH (2)9.6: Attach Door Spring (HD) to Handle assembly. Set the Door aside.HD (1)Us

Strany 9 - Floor Assembly

24Second person should apply pressure on opposite side of the wall for easy insertion of screws.Seprthscrews.12.1: Assemble the two halves of the Rear

Strany 10 - Front Corner Assembly

18Doors and Front Gable Installation1111.1: Push a Door Hinge Bushing (HS) up through the hole in the ﬂ oor.11.2: Hang the Left Door on the left fro

Strany 11 - Left Wall Assembly

22HR**U.S. and Canada customers ONLY**IF ASSISTANCE IS NEEDED, DO NOT CONTACT THE STORE!!!CALL OUR CUSTOMER SERVICE DEPARTMENT at 1 (800) 225-3865HOUR

Strany 12 - Back Wall Assembly

28/08/2008MODEL # 60018Lifetime 8’ x 10’ Outdoor ShedREGISTER YOUR LIFETIME PRODUCT TODAY!There are beneﬁ ts to registering your Lifetime product. Wit

Strany 13 - Right Wall Assembly

20105106107111112113114115116117104109110108Shed Parts(Not actual size)Before Beginning AssemblyRemove this Parts List and Hardware Identiﬁ er from th

Strany 14 - Truss & Roof Installation

38NOTES:3A. Read the “Congratulations” letter on pages 4-5.B. Remove Parts List from the center of these instructions and make sure all parts are pr

Strany 15 - Right Door Assembly

44Dear Valued Customer,We would like to congratulate you on your purchase of a Lifetime® Outdoor Storage Shed! We are conﬁ dent that you have made the

Strany 16 - Truss Assembly

368’ (2,44 m)10’ (3,05 m)17.1: After assembling your shed, you will need to anchor it to the ground through the four indentations in the shed ﬂ oor. C

Strany 17 - Front Gable Assembly

6118 1/4”93 1/2”1Site Selection1.2: Wherever possible you should use the surfaces described above. When this is not possible, we recommend you use on

Strany 18

3414.17: Position and Secure Center Roof Cap (117) along Truss.14.18: Connect centers of Roof Caps (117).SS (2)CAUTIONOnly hand tighten screws in Roof

Strany 19 - Parts List

8OPTION 2: Filled Wood FrameO2.5: Once all boards are level and do not wobble, pack “Pea” gravel or dirt around the outside of the frame, and slope a

Strany 20 - Shed Parts

3214.14: Install Rear Gable. SS (14)Hardware Bags:1001632Screwdriver14.13: Connect the centers of the two Roof Caps (117) with Screws (SS).Hardware Ba