Sharp Z-336J Uživatelský manuál Strana 215

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 224
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 214
15-61
Chapter 15: Appendix
15
[4] Installation of network equipment in an FL-net
Shown below is an example installation of network equipment in an FL-net system.
1. Install a transceiver in a metal box using a wooden board for insulation. The box must have a class D
ground.
2. Run the transceiver cable to the controller control panel through metal conduit. Provide a class D
ground for the conduit.
3. Install a hub inside the controller control panel using a metal, U shaped bracket. Use a hub that is
electrically isolated from the metal mounts, such as by using rubber feet. Ground the hub mounts to
the control panel. The control panel must be provided with a class D ground.
Installation example of network equipment in an FL-net
Controller control panel
Transceiver installation box
Transceiver isolation plate
(wooden board)
Coaxial cable
Transceiver cable
(AUI cable)
Transceiver cable
(AUI cable)
Transceiver main housing
Conduit
Conduit
U shaped hub mounting bracket
Hub
10BASE-T cable
Controller control panel
Zobrazit stránku 214
1 2 ... 210 211 212 213 214 215 216 217 218 219 220 ... 223 224

Komentáře k této Příručce

Žádné komentáře