Sharp AR-650 Servisní příručka stáhnout pdf (Strana 317)

100

101

16 - 17 ADF

(14)

Aligning sensor OFF to timing sensor OFF

The feed motor stops at the point when the timing sensor turns OFF. When the 2nd original onwards

is being fed, exit of exposed originals is carried out at the same time, and the original being fed must

be made to stand by before the reversal section until exit is completed. For this reason, the number of

drive pulses up to feed motor stop is set at the point when the timing sensor turns OFF to stop the

original being fed before the reversal section.

(15)

Timing sensor OFF to pause of forward rotation transport

After the timing sensor turns OFF, the original is transport for a specified number of pulses, and the

feed motor stops at the point when the original being fed arrives at the specified position before the

reversal section. The original stands by until exit of the output original is completed. The number of

drive pulses up to start of exit deceleration is set at the point when the turn guide sensor turns ON by

the leading edge of the output original, deceleration of the reversal motor is started at the point when

the timer has counted the number of pulses, and the original is output at low speed.

(16)

Completion of exit

At the point when the original is completely output onto the exit tray, the reversal motor stops, and exit

is completed.

1 2 ... 312 313 314 315 316 317 318 319 320 321 322 ... 395 396

Komentáře k této Příručce

Žádné komentáře

Sharp AR-650 Servisní příručka Strana 317

Komentáře k této Příručce

Související produkty a manuály pro Multifunkční zařízení Sharp AR-650