Sharp MD-R3 Provozní pokyny stáhnout pdf (Strana 38)

(Continued)

● The stop time setting display will appear.

● The “hours” display will be automatically increased one hour.

■ Timer recording

Before timer recording, the following preparations are required.

● Load a recordable MD.

1 While in the stop mode, press the TIMER button, and then

turn the jog dial until "TIMER SET" appears.

2 Within 10 seconds, press the ENTER button, and then select

"TIMER REC" using the jog dial.

3 Press the ENTER button.

● The start time setting display will appear.

4 Enter the “hour”, using the jog dial. Then, press the ENTER

button.

5 Enter the “minute”, using the jog dial. Then, press the ENTER

button.

● The stop time setting display will appear.

6 Enter the “hour”, using the jog dial. Then, press the ENTER

button.

7 Enter the “minute”, using the jog dial. Then, press the ENTER

button.

● The start and stop times are now set.

8 Select the source program using the jog dial.

ANALOG → DIGITAL OPT → DIGITAL COAX

● If you select the analog input, adjust the recording level. (Page

22)

9 Press the ENTER button.

Setting timer for recording:

1 Press the TIMER button, and then select "T-STANDBY" using

the jog dial.

2 Press the ENTER button.

● The settings will appear in order, and the unit will enter the

timer recording stand-by mode. (The power will be turned off.)

Preparations for any equipment connected to this unit

Any equipment, such as a stereo, that is connected to this unit

should be set up in advance as follows:

● Set it up so that music to be recorded will be played at the

same time as the timer’s start time.

ENTER

DELETE/CLEAR

TIMER

REC LEVEL

MAX

MIN

When the digital optical input was selected

TIMER REC

Timer recording indicator

(Timer stand-by mode)

MD-R3

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 47 48

Komentáře k této Příručce

Žádné komentáře

Sharp MD-R3 Provozní pokyny Strana 38

Komentáře k této Příručce

Související produkty a manuály pro Minidisc přehravače Sharp MD-R3