Sharp PC-9800T Manuál s instrukcemi stáhnout pdf (Strana 186)

6・34

Chapter 6 Program Edit (Ladder Programming)

2. Assign the reading position.

□ Insert to Cursor Position.

Read out to the row that contains the cell cursor of the [Program : Ladder] window.

□ Insert to Assigned Row.

Read out to the assigned row of the [Program : Ladder] window.

3. When there is a ladder circuit on the assigned line of the [Program : Ladder] window, select

either "over write" on the ladder circuit, or "insert" in front of the ladder circuit.

4. Setup the number of times of the ladder circuit being read continuously on the "repeat time."

In case you setup more than two times, read out by increasing /decreasing the relay

address or the register address , according to the number of increased/ decreased value.

If the number of repeat is one time, the increase /decrease value will not be affected.

5. If you click [OK] button, the reading of the ladder circuit to the [Program : Ladder] window will

start.

Example of the number of repeat being three times.

First reading

Second reading

Third reading

1 2 ... 181 182 183 184 185 186 187 188 189 190 191 ... 270 271

Žádné komentáře

Sharp PC-9800T Manuál s instrukcemi Strana 186