Sharp XE-A404 Alpha Numeric Thermal Manuál s instrukcemi

Procházejte online nebo si stáhněte Manuál s instrukcemi pro Pokladny Sharp XE-A404 Alpha Numeric Thermal . Sharp XE-A404 Alpha Numeric Thermal Instruction manual Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 17
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
XE-A203 and XE-A203B Frequently Asked Questions Page 1 of 17
XEA203 and XEA203B Frequently asked
questions.
How do I prepare my XEA203 for set-up?
Take the XEA203 out of its box, remove the packing materials. Place the XEA203 on
a flat stable surface, close to a power outlet. Also insure it will not be exposed to
direct sunlight, and is away from water (taps, sinks, etc).
How do I clear the XEA203 to ready it for programming?
It is very important that you “initialise” the XEA203 correctly once you have
removed it from the box, and are ready to start programming. If you do not
“initialise” the XEA203, it might not work correctly.
1. Insert the MA key into the mode switch and turn it to the REG position.
2. Insert the plug of the power cord into a power outlet.
This must be done without the batteries installed. If you have installed
batteries; be sure to remove them before you start this procedure.
The display will show: *** MRS. *** for about six seconds. The buzzer will
then sound three times. If the buzzer does not sound three times, please try
again.
The cash register has now been “initialised”. If there were any data from a previous
programming attempt it would have been cleared. The display should now show:
NO BATTERY.
Zobrazit stránku 0
1 2 3 4 5 6 ... 16 17

Shrnutí obsahu

Strany 1

XE-A203 and XE-A203B Frequently Asked Questions Page 1 of 17 XEA203 and XEA203B Frequently asked questions. How do I prepare my XEA203 for set-up?

Strany 2

XE-A203 and XE-A203B Frequently Asked Questions Page 10 of 17 9. Enter the sixth (last) line do the following: #/TM/ST 4 _●_ 6 __ use

Strany 3

XE-A203 and XE-A203B Frequently Asked Questions Page 11 of 17 How do I set the printer to print a receipt or a journal? The XEA203’s printer can be

Strany 4

XE-A203 and XE-A203B Frequently Asked Questions Page 12 of 17 How do I make the decimal point key work; so I can sell other than full units. For: ex

Strany 5 - How do I set a 10% GST rate?

XE-A203 and XE-A203B Frequently Asked Questions Page 13 of 17 How shall I know when it is time to replace the batteries? The XEA203 will display a l

Strany 6

XE-A203 and XE-A203B Frequently Asked Questions Page 14 of 17 How do I make a sale? 1. Turn the mode key to REG 2. Sign on a clerk. For example

Strany 7

XE-A203 and XE-A203B Frequently Asked Questions Page 15 of 17 The XEA203 displays “OVER LIMIT” when I try to finalise a sale to cash. How do I fix t

Strany 8

XE-A203 and XE-A203B Frequently Asked Questions Page 16 of 17 How do I produce sales reports? There are two type types of reports: X or e(X)amine r

Strany 9

XE-A203 and XE-A203B Frequently Asked Questions Page 17 of 17 To produce a daily Z report, do the following: 3. Turn the mode key to X1/Z1 position

Strany 10

XE-A203 and XE-A203B Frequently Asked Questions Page 2 of 17 How to install the batteries, and why should I do so? The XEA203 uses 3 x AA size batte

Strany 11

XE-A203 and XE-A203B Frequently Asked Questions Page 3 of 17 What sort of paper roll do I use, and how do I install it? The XEA203 uses a thermally

Strany 12

XE-A203 and XE-A203B Frequently Asked Questions Page 4 of 17 4. Feed the end of the paper along with the paper position guides as shown in the diagr

Strany 13

XE-A203 and XE-A203B Frequently Asked Questions Page 5 of 17 How do I set the time and date? 1. Set the mode key to the PGM position. 2. Enter t

Strany 14 - How do I make a sale?

XE-A203 and XE-A203B Frequently Asked Questions Page 6 of 17 How do I set a Department as taxable or not taxable? 1. Set the mode key to the PGM po

Strany 15 - #/TM/ST

XE-A203 and XE-A203B Frequently Asked Questions Page 7 of 17 How do I set the letters GST to print on the receipt? 1. Set the mode key to the PGM p

Strany 16

XE-A203 and XE-A203B Frequently Asked Questions Page 8 of 17 How do I give a department a descriptive name? 1. Set the mode key to the PGM position

Strany 17

XE-A203 and XE-A203B Frequently Asked Questions Page 9 of 17 How do I get my business name and ABN to print on the receipt? 1. Set the mode key to

Komentáře k této Příručce

Žádné komentáře