Sharp LC-20S2U Servisní příručka stáhnout pdf (Strana 52)

100

LC-20S2U-S

VOLTAGE MEASUREMENT CONDITION:

1. The voltages at test points are measured on

exclusive AC adaptor and the stable supply voltage

of AC 120V. Signals are fed by a color bar signal

generator for servicing purpose and the above

voltages are measured with a 20k ohm/V tester.

INDICATION OF RESISTOR & CAPACI-

TOR:

RESISTOR

1. The unit of resistance “Ω” is omitted.

(K=kΩ=1000 Ω, M=MΩ).

2. All resistors are ± 5%, unless otherwise noted.

(J= ± 5%, F= ± 1%, D= ± 0.5%)

3. All resistors are 1/16W, unless otherwise noted.

4. All resistors are Carbon type, unless otherwise

noted.

: Solid

: Cement

: Oxide Film

: Special

: Metal Coating

CAPACITOR

1. All capacitors are µF, unless otherwise noted.

(P=pF=µµF).

2. All capacitors are 50V, unless otherwise noted.

3. All capacitors are Ceramic type, unless otherwise

noted.

(ML): Mylar (TA): Tantalum

(PF): Polypro Film (ST): Styrol

CAUTION:

This circuit diagram is original one, therefore there may be a

slight difference from yours.

IMPORTANT SAFETY NOTICE:

PARTS MARKED WITH “

” ( ) ARE

IMPORTANT FOR MAINTAINING THE SAFETY OF

THE SET. BE SURE TO REPLACE THESE PARTS

WITH SPECIFIED ONES FOR MAINTAINING THE

SAFETY AND PERFORMANCE OF THE SET.

AVIS DE SECURITE IMPORTANT:

LES PIECES MARQUEES “

” ( )SONT

IMPORTANTES POUR MAINTENIR LA SECURITE

DE L'APPAREIL.

NE REMPLACER CES PIEDES QUE PAR DES

PIECES DONT LE NUMERO EST SPECIFIE POUR

MAINTENIR LA SECURITE ET PROTEGER LE BON

FONCTIONNEMENT DE L'APPAREIL.

DESCRIPTION OF SCHEMATIC DIAGRAM

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 99 100

Komentáře k této Příručce

Žádné komentáře

Sharp LC-20S2U Servisní příručka Strana 52

Komentáře k této Příručce

Související produkty a manuály pro Televizory a monitory Sharp LC-20S2U