Sharp FO-2950M Uživatelský manuál Strana 27

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 152
  • Tabulka s obsahem
  • ŘEŠENÍ PROBLÉMŮ
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 26
Setting Up the Multifunction Interface
25
1. Installation
Note: There is normally no need to change the parallel port setting in
your computer's setup (BIOS) program. However, if you find that the
Sharp Laser Multifunction fax does not operate well when scanning or
printing, you may need to change the setting. In this case select ECP,
PS2, Bi-directional, or an equivalent parallel port mode.
3
Connect the other end of the cable to
the parallel port on the back of your
computer.
2
Connect one end of the cable to the
port on the Sharp Laser
Multifunction. Snap the clips on each
side of the port onto the cable
connector to secure it.
all-fo2950.book Page 25 Monday, September 25, 2000 8:57 AM
Zobrazit stránku 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 151 152

Komentáře k této Příručce

Žádné komentáře