Sharp SYSTEM 8/10 Plus Provozní pokyny stáhnout pdf (Strana 48)

Extron • System 8/10 P

LUS

• User’s Manual

Multiple Switcher Operation

System 8/10 PLUS Switch Settings

From the front access panel on the System 8/10 PLUS, do the following:

1. On DIP switch block SW15, set switches #6 and #8 “up”.

2. Set rotary switch RS4 to the “0” position (RS-232 mode).

On the rear panel of the System 8/10 PLUS, do the following:

3. Set the Norm/VLB switch on the back of the 8/10 PLUS to “Norm”.

4. Set the Address switches for “master”. (If looping two 8/10 PLUS systems to the

System 4, the second one must be set as a “slave”.)

5. Set the Video/RGBS switches to match the type of video to be used by each

input and do the configuration setup.

Go to page 4-7 of the System 4 User’s Manual to configure the master/slave as a system.

_____ Refer to the previous pages for other switch settings.

Looping with System 4

5-9

L R L R

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 77 78

Žádné komentáře

Sharp SYSTEM 8/10 Plus Provozní pokyny Strana 48