
Appendix
Removing the Stand
• Before detaching (or attaching) the stand, unplug the AC cord from the AC INPUT terminal.
BmirD
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching the stand
• Before performing work, make sure
to
turn off the
TV.
• Before performing work spread cushioning over the base area
to
lay the TV on. This will prevent it from being
damaged.
1
,~
..
n
ff
Hex key
---,~
+t
2
Unfasten the four screws used
to
secure the stand
in
place.
IDD
• To attach the stand, perform the above steps
in
reverse order.
Setting the TV on the Wall
Detach the stand from the
TV.
(Hold the stand so it
will not drop from the edge
of
the base area.)
BmirD
• This TV should be mounted on the wall only with the wall mount bracket AN-52AG4 (SHARP). The use of other wall
mount brackets may result
in
an unstable installation and may cause serious injuries.
• Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or mounting
that results
in
accident
or
injury.
Using an optional bracket to mount the TV
• You can ask a qualified service professional about using
an
optional AN-52AG4 bracket to mount the
TV
on
the wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-52AG4 wall mount bracket.
(See the bracket instructions for details.)
About setting the TV angle
• The "d" position
is
at the
center
of
the display.
• Refer to the operation
manual
of
AN-52AG4 for
details.
1m
• Detach the cable clamp on the rear ofthe
1V
when using the optional mount bracket.
• To use this
1V
mounted on a wall, remove the covers at the 4 locations on the rear of the 1V, and then use the screws
supplied with the wall mount bracket to secure the bracket to the rear of the 1V.
@-
38
Komentáře k této Příručce